Home › Set / Grub Screws › M5 grub
M5 set screw size
2.5 mm hex key
Allen / internal hex key size for M5 grub
M5 set screw — pulleys, gears and couplings.
Full specification
| System | Metric (45H) |
| Nominal diameter | 5 mm |
| Thread pitch | 0.8 mm |
| Hex key (Allen) | 2.5 mm |
| Tap drill | 4.2 mm |
| Clearance hole | n/a (threaded) |
| Common grade / class | 45H |
| Typical torque | 3.4 Nm (2.5 ft·lb) |
| Closest other-system size | ~#10 imperial |
🔧 Torque unit converter
Pre-filled with the typical torque for M5 grub (45H, dry). Edit any field to convert.
⚠️ Torque values here are general references for 45H on clean, dry threads. Lubrication, coatings, and the joint material change the figure significantly. For structural, automotive, or safety-critical work, always use the torque specified by the manufacturer or engineer.
About M5 grub
M5 grub screws secure gears and couplings on motor shafts.
A flat machined on the shaft gives an M5 grub far better grip.
Frequently asked questions
- What size Allen / hex key fits M5 grub?
- M5 set screw uses a 2.5 mm hex (Allen) key with an internal hex drive.
- What is the torque for M5 grub?
- A typical tightening torque for M5 set screw in 45H on dry threads is about 3.4 Nm (2.5 ft·lb). Always confirm against the manufacturer spec for important joints.
- What thread pitch and tap drill does M5 grub use?
- M5 set screw has a thread pitch of 0.8 mm and uses a 4.2 mm tap drill, with a n/a (threaded) clearance hole.