Home › Imperial / SAE Bolts › 7/16 in
7/16-inch bolt size
5/8 in wrench
across-flats spanner / socket size for 7/16 in
7/16-inch bolt — automotive and equipment.
Full specification
| System | Imperial UNC |
| Nominal diameter | 7/16 in (11.11 mm) |
| Thread pitch | 14 TPI |
| Wrench / spanner (across flats) | 5/8 in |
| Tap drill | U (9.3 mm) |
| Clearance hole | 29/64 in |
| Common grade / class | Grade 5 |
| Typical torque | 75 Nm (55 ft·lb) |
| Closest other-system size | ~M11 |
🔧 Torque unit converter
Pre-filled with the typical torque for 7/16 in (Grade 5, dry). Edit any field to convert.
⚠️ Torque values here are general references for Grade 5 on clean, dry threads. Lubrication, coatings, and the joint material change the figure significantly. For structural, automotive, or safety-critical work, always use the torque specified by the manufacturer or engineer.
About 7/16 in
7/16-14 is a less common mid-size imperial bolt, seen in older machinery.
7/16 in sits between 3/8 and 1/2 — keep the right socket on hand.
Frequently asked questions
- What size wrench or spanner fits 7/16 in?
- 7/16-inch bolt uses a 5/8 in wrench or spanner, measured across the flats of the hex head.
- What is the torque for 7/16 in?
- A typical tightening torque for 7/16-inch bolt in Grade 5 on dry threads is about 75 Nm (55 ft·lb). Always confirm against the manufacturer spec for important joints.
- What thread pitch and tap drill does 7/16 in use?
- 7/16-inch bolt has a thread pitch of 14 TPI and uses a U (9.3 mm) tap drill, with a 29/64 in clearance hole.